Visualisations de cotes: POSITIP 880

Spécifications techniques

	POSITIP 880
Axes	Up to 6 axes from A to Z and ZO, ZS
Encoder inputs	6 x 1 VPP, 11 µAPP or EnDat 2.1; D-sub female 15-pin (automatic interface recognition)
Input frequency	≤ 100 kHz
Signal period	0.128 µm, 2 µm, 4 µm, 10 µm, 20 µm, 40 µm, 100 µm, 10 240 µm, 12 800 µm
Line count	Any
Subdivision factor	Max. 1024-fold
Display step 1)	Linear axis: 1 mm to 0.005 µm Angular axis: 0.01° to 0.000 1° (00° 00‘ 01‘‘)
Display	Color flat screen for position values, dialog and input displays, graphic functions, graphic positioning support and contour monitoring
Status display	Operating mode, REF, reference-point number, tool number, inch, scale, feed-rate display, stopwatch
For milling/drilling/boring	Tool compensation R+, R–
For turning	Radius/diameter display; separate or sum display for Z and ZO
Functions	REF reference-mark evaluation for distance-coded or single reference marks Distance-to-go mode, nominal position input (absolute or incremental) Scaling factor Contour monitoring with magnify function Any axis combinations HELP: On-screen operating instructions INFO: Stopwatch, pocket calculator, cutting data calculator (for milling), taper calculator (for turning)
For milling/drilling/boring	99 datums and 99 tools Calculation of positions for hole patterns (circular patterns as well as linear patterns) Tool radius compensation Probing function for datum acquisition with the KT edge finder: "Edge," "Centerline" and "Circle center" Positioning aids for milling and the roughing out of a rectangle pocket
For turning	1 datum, 99 tools Freezing tool position for back-off Oversize allowances
Programming	Up to 999 program blocks per program; sub programming capability with turning and mirroring; teach-in programming
Cycles For milling/drilling For turning	Line segments, circular arcs, chamfers, circular and linear hole patterns, rectangular pockets Line segments, circular arcs, chamfers, multipass
Error compensation	Linear and multipoint, up to 128 measuring points
Interfaces Serial Parallel	RS-232-C/V.24 300 to 115 200 baud For output of programs, measured values and parameters For loading of programs and parameters Centronics for output of measured values
Switching I/O	Via IOB 89 external input/output unit 1 input for KT edge finder
Accessories	KT edge finder (milling) tilting base, tilt/swivel mount, pivot arm
Power connection	100 V to 240 V AC (–5 % to +10 %), 48 Hz to 62 Hz; 35 W
Operating temperature	0 °C to 45 °C (storage temperature –20 °C to 70 °C)
Protection EN 60 529	IP 40, front panel IP 54
Weight	Approx. 3.2 kg
1) Depends on the signal period or line count of the connected encoder